Rubber Molding Manufacturers

Forging Process is one of the two components of forging (forging and stamping), in which forging machine is used to press metal billet to produce plastic deformation and Electric Power Fittings so as to obtain forging with certain mechanical properties, shape and size.
According to the way the blank moves, forging can be divided into free forging, upsetting, extrusion, die forging, closed die forging, closed heading forging. 1.Free forging. Use the impact force or pressure to deform the metal between the upper and lower iron (anvil block) to obtain the required forgings, mainly manual forging and mechanical forging two kinds.
2.Die forging. Die forging is divided into open die forging and closed die forging. The metal blank is obtained by compression deformation in the forging die bore of a certain shape, which can be divided into cold heading, roll forging, radial forging and extrusion, etc.
3, closed die forging and closed heading forging because there is no flying edge, the utilization rate of materials is high. It is possible to finish complex forgings with one or several processes. Since there is no flying edge, the forgings have less force area and less load required. However, it should be noted that the blank can not be completely restricted, so it is necessary to strictly control the volume of the blank, control the relative position of the forging die and measure the forging die, and try to reduce the wear of the forging die.

METALLECA® Bucket Teeth of Excavator is required high performance and assembly. There is a mature standardized production including production, manufacturing and control processes from blank to heat treatment. In the casting process, we focus on mold design, pouring temperature, iron and molten steel clarity (exhaust gas, slag removal), material chemical composition, pouring speed, blank surface treatment and dimensional stability of assembly. In the heat treatment, we also consider mechanical properties of heat treatment, anti-rust treatment (such as painting), and the standard packaging and pallet methods to the final shipment.

The effect of METALLECA® Car Chassis Suspension Aluminum Swing Arm Bracket are to prevent the rod twist when the horizontal height of the left and right wheels is different. The balance bar creates roll resistance that inhibits car body rolling. In other words, the balance bar does not work when the suspension of the left and right syncs up and down. The balance bar only works if the left and right suspensions are caused by incongruous movements because of undulating or turning over bends on the road surface. The intelligent and mechanized of automobile manufacturing industry has been rapid developed in recent years. Especially with the rise of new energy vehicles and domestic brands, the demand for auto parts will be growing in the market. In addition, the quality, price and service of the auto market will face huge challenges.

METALLECA® Harvester Accessories are applied in agricultural machinery. The agricultural machinery is rapid widespread and obviously improvement the efficiency of agricultural production. The rapid development of agricultural mechanization is one of the important characteristics in modern agriculture. Especially, the modern intelligent manufacturing has accelerated agricultural mechanization, modern agriculture, and agricultural production to meet market demand. Therefore, the production of harvester and related machinery parts are gradually increasing in demand.

METALLECA® Mechanical Equipment Exhaust Pipes made in China are mainly used in agricultural machinery, automobiles, and construction machinery. They need to have good heat dissipation and sealing properties for the function of exhausting gas, purifying exhaust gas, reducing noise.
The materials of Mechanical Equipment Exhaust Pipes are no longer limited to the steel and pig iron on the market. The thin and light stainless steel and titanium alloys have gradually replaced pervious materials. Our company supplies the material of aluminum alloy in current.

METALLECA® Motor housings are widely used in generators and electric motor series. The power of motor is range from 1KW to 20KW. The materials of the housing are no longer limited to steel and pig iron as in the past, then the thin and lightweight stainless steel and aluminum alloy are also more popular. Our production of motor housing is made aluminum alloy and common carbon steel. The housing of the motor has a protective effect and functions as a component mounting frame. In addition, some special models of motor housings also have functions with heat dissipation or sound insulation.