standard excavator bucket Manufacturers

METALLECA® Special Shaped Gaskets from our factory are formed by presses and molds to apply external force to plates, strips, pipes and profiles that result in plastic deformation or separation. Then, the stamping pieces acquire the needs of shape and size.
With the rapid development of technology and improvement of equipment requirement, the demand for precision accuracy stamping pieces is increasing and the applications are getting wider.

The METALLECA® rubber coated drive wheel is the general term of many mechanical parts that can change the scope of physical movement. The most important function is to change the force, torque or speed by combining a drive wheel set of more than two different diameters wheels. At present, the materials of drive wheel are no longer limited to the steel, pig iron, but aluminum alloy and plastics gradually also occupy in the market.

The effect of METALLECA® Car Chassis Suspension Aluminum Swing Arm Bracket are to prevent the rod twist when the horizontal height of the left and right wheels is different. The balance bar creates roll resistance that inhibits car body rolling. In other words, the balance bar does not work when the suspension of the left and right syncs up and down. The balance bar only works if the left and right suspensions are caused by incongruous movements because of undulating or turning over bends on the road surface. The intelligent and mechanized of automobile manufacturing industry has been rapid developed in recent years. Especially with the rise of new energy vehicles and domestic brands, the demand for auto parts will be growing in the market. In addition, the quality, price and service of the auto market will face huge challenges.

METALLECA® Bucket Teeth of Excavator is required high performance and assembly. There is a mature standardized production including production, manufacturing and control processes from blank to heat treatment. In the casting process, we focus on mold design, pouring temperature, iron and molten steel clarity (exhaust gas, slag removal), material chemical composition, pouring speed, blank surface treatment and dimensional stability of assembly. In the heat treatment, we also consider mechanical properties of heat treatment, anti-rust treatment (such as painting), and the standard packaging and pallet methods to the final shipment.

Forging Process is one of the two components of forging (forging and stamping), in which forging machine is used to press metal billet to produce plastic deformation and Electric Power Fittings so as to obtain forging with certain mechanical properties, shape and size.
According to the way the blank moves, forging can be divided into free forging, upsetting, extrusion, die forging, closed die forging, closed heading forging. 1.Free forging. Use the impact force or pressure to deform the metal between the upper and lower iron (anvil block) to obtain the required forgings, mainly manual forging and mechanical forging two kinds.
2.Die forging. Die forging is divided into open die forging and closed die forging. The metal blank is obtained by compression deformation in the forging die bore of a certain shape, which can be divided into cold heading, roll forging, radial forging and extrusion, etc.
3, closed die forging and closed heading forging because there is no flying edge, the utilization rate of materials is high. It is possible to finish complex forgings with one or several processes. Since there is no flying edge, the forgings have less force area and less load required. However, it should be noted that the blank can not be completely restricted, so it is necessary to strictly control the volume of the blank, control the relative position of the forging die and measure the forging die, and try to reduce the wear of the forging die.

Our company is an OEM/ODM supplier. Our METALLECA® Hydraulic Valve Body Connector can be customized according to requirement of domestic and foreign customers. Production would follow customer’s specific requirements (assembly, performance, life, corrosion resistance, etc.) to select the appropriate processes and materials (mainly used aluminum alloy, stainless steel, carbon steel). Otherwise, the production and processing are based on the customer specification. We specialize in producing unpatented products and do not have our own brand. At present, we supply for supporting machinery and equipment to domestic and foreign customers only. We look forward to more inquiries and cooperation with new customers to become long-term partnership.