Industry News

Introduction to stamping parts

2021-08-26
Of the world's steel, 60 to 70% are plates, most of which are stamped into finished products. The car body, chassis, fuel tank, radiator fins, boiler drums, container shells, motors, electrical iron core silicon steel sheets, etc. are all stamped and processed. There are also a large number of stamping parts in products such as instruments, household appliances, bicycles, office machinery, and living utensils.
Compared with castings and forgings, stamping parts have the characteristics of thinness, uniformity, lightness and strength. Stamping can produce workpieces with stiffeners, ribs, undulations or flanges that are difficult to manufacture by other methods to improve their rigidity. Due to the use of precision molds, the precision of the workpiece can reach the micron level, and the repeatability is high, the specifications are consistent, and holes, bosses, etc. can be punched out.
Cold stamping parts are generally no longer processed by cutting, or only a small amount of cutting processing is required. The precision and surface condition of hot stamping parts are lower than cold stamping parts, but still better than castings and forgings, and the cutting amount is less.
Stamping is an efficient production method. Using compound dies, especially multi-station progressive dies, multiple stamping processes can be completed on one press, and the entire process from strip uncoiling, leveling, punching to forming and finishing can be achieved. Automatic production. The production efficiency is high, the working conditions are good, and the production cost is low. Generally, hundreds of pieces can be produced per minute.
Stamping is mainly classified by process, which can be divided into two categories: separation process and forming process. The separation process is also called punching, and its purpose is to separate the stamping parts from the sheet along a certain contour line while ensuring the quality requirements of the separated section. The surface and internal properties of the sheet metal used for stamping have a great influence on the quality of the stamping product. The thickness of the stamping material is required to be accurate and uniform; the surface is smooth, without spots, scars, scratches, and surface cracks, etc.; the yield strength is uniform, and there is no obvious Directionality; high uniform elongation; low yield ratio; low work hardening.
We use cookies to offer you a better browsing experience, analyze site traffic and personalize content. By using this site, you agree to our use of cookies. Privacy Policy
Reject Accept